Latest activity

What's new New posts Latest activity
  • phantomkartracer
    phantomkartracer reacted to Pete_Muller's post in the thread Kt100 ring size with Like Like.
    Like Sundog says: gap really doesn't matter much as long as there is "enough". Fit and tension matter though. I have literally... at...
  • SoCo Tire Treatments
    SoCo Tire Treatments replied to the thread Qualifying tires.
    Id argue the health hazard a bit, when actually was the last time the tire caused a health issue. Next is the myth that you need...
  • flattop1
    flattop1 replied to the thread Alternator test..
    Computer and anti theft seem like they are always on . Pretty much accepted, pull the batt cable if I leave it sit .
  • S
    silverback reacted to shiftyag's post in the thread Kt100 ring size with Like Like.
    One that fits the bore........we always ran o&h rings cast or gold and were available in 52.6, 52.7 etc. we used the one that fit, check...
  • flattop1
    flattop1 reacted to JLSRacing's post in the thread Alternator test. with Like Like.
    I have use a 12dcv test light for checking low draws. Remove a battery cable put the test light in series. Start with key off. Don’t...
  • S
    silverback reacted to OVALTECH1's post in the thread Hemi predator 212 with Like Like.
    where ya located I got a brand new one still in the box ?
  • M
    Mark @ EC replied to the thread HL 388B Carburettor.
    Don't idle the carburetor; close the butterfly completely. Keep the engine running with your throttle, and try the needles 2-2.5 on the...
  • B
    bullerman replied to the thread Hemi predator 212.
    I bought a new non hemi. The springs looked like the one on the left. Just wonder if they would actually hurt a stocker like with a...
  • JLSRacing
    JLSRacing replied to the thread Alternator test..
    I have use a 12dcv test light for checking low draws. Remove a battery cable put the test light in series. Start with key off. Don’t...
  • JPMKarting
    JPMKarting replied to the thread Plate bolts.
    20V 3/8, cant get too carried away. In all seriousness though, they dont need to be extremely tight...snug with just a little extra...
  • Dougherty#39
    Dougherty#39 replied to the thread 2019 Phantom deuce.
    Bump
  • flattop1
    flattop1 replied to the thread HL 388B Carburettor.
    Ten 4. When you turn the idle speed screw in. Will it idle up ? I assume it will , only too high. Start small 1/8" .
  • spincycle
    spincycle reacted to Colt sr's post in the thread Looking for help.., with Like Like.
    Most Honda shops only do factory or minor repairs nowadays. They are quick to sell you a new engine before opening up your old one. If...
  • B
    boomer741 replied to the thread kart sellout.
    ttt
  • spincycle
    spincycle reacted to flattop1's post in the thread Looking for help.., with Like Like.
    Roger. full rebuild vs just a piston and clean up . Could change choices.
Show older items
Back
Top