-
-
LLucky_7 replied to the thread Phantom Stalker Spindles.I can tell you in a few days. I have a guy whos going to try them. They look the same on PRC website.
-
LLucky_7 replied to the thread Phantom Stalker Spindles.1 Set available.
-
LLucky_7 replied to the thread Phantom Stalker Spindles.PM Sent
-
LLucky_7 replied to the thread Phantom Stalker Spindles.Eastern Oklahoma
-
LThese are built thicker, with the 3/4-5/8 shaft on the right side. Pill style, I have 2 sets, 125 a set. Buyer pays shipping. I might...
-
-
LLucky_7 replied to the thread Сonnecting rod bearing damage..Just a normal old school machinist here, but I've seen this type of damage before. It was not in an engine, but a prototype pump. The...
-
LLucky_7 replied to the thread Attention All Certified Tech.So then what do the rules say on the short side radius, or the valve pocket in general. Does the defined edge rule cover the entire...
-
LLucky_7 replied to the thread Attention All Certified Tech.Just for clarification. When you say D shape port, is that the part of the runner closest to the valve pocket? You cant smooth that...
-
-
Loading…
-
Loading…
