M
Reaction score
22

Latest activity Postings About

    • M
      michael collins replied to the thread kt 100 power.
      Yes I have and when the plug gets to close I run the recessed plug to move the heat away but if you try to recut a head that was set at...
    • M
      michael collins replied to the thread kt 100 power.
      If you take a head that's been cut to 11cc for IKF or WKA and try to cut it down to 9cc you will get the plug to close to the piston, if...
    • M
      michael collins replied to the thread kt 100 power.
      Put exhaust at 90 degrees, transfers at 115 to 116 degrees, intake at 90 degrees, squish at .030 14degree angle 10CCs . Jon Brogden has...
    • M
      michael collins replied to the thread KT 100 tricks.
      Put exhaust at 90 degrees, transfers at 115 to 116 degrees, intake at 90 degrees, squish at .030 14degree angle 10CCs . Jon Brogden has...
    • M
      michael collins replied to the thread Q98 pipe.
      Mike I would be interested in the Q98
    • M
      Do you have a picture showing 7 transfers and then what type exhaust ports does this engine have
    • M
      Buller's KB-06 or his new KB-L6 would work just fine on gas.
    • M
      michael collins replied to the thread 250MX Billet cases.
      Their Mikuni's and yes the 250 can take a lot of carb I have one 34mm on top and a 36mm on bottom
    • M
      michael collins replied to the thread 2 cycle exhaust.
      Yes and also Give me your address and I will send you a trigger, I have one left you can have it just pay the shipping. A trigger is a...
    • M
      michael collins replied to the thread 2 cycle exhaust.
      It will tell you where the pipe is working better, clutch slip goes up that pipe makes better bottom, just the opposite is clutch drops...
  • Loading…
  • Loading…
Top