Pete_Muller
Reaction score
607

Latest activity Postings About

    • Pete_Muller
      Pete_Muller replied to the thread What is the best KT100 Pipe.
      You may be expecting a lot out of a DD Yamaha! haha! Try going .025"-.030" milder on the intake timing. I remember mine pulling quite...
    • Pete_Muller
      Pete_Muller replied to the thread What is the best KT100 Pipe.
      Many, MANY years ago I set up a sprint kart with a direct-drive Yam. Engine was to the WKA specs, except I ran the intake port .025"...
    • Pete_Muller
      Pete_Muller replied to the thread Help. Axle issue.
      Legend, I'm in no way implying that a carbon tube won't prevent a hub from moving inward -- I'm sure it's plenty strong enough, and...
    • Pete_Muller
      Pete_Muller replied to the thread Help. Axle issue.
      As an FYI on a carbon-fiber sleeve (made from bias weave, like the one in the photo).... That will have about 1/10th the compressive...
    • Pete_Muller
      I "believe" the 403 may be a bit on the hot side for an open on methanol.
    • Pete_Muller
      "..... pretty good out of the hole". ??? That's an understatement!! Though it appears far more the driver than the engine! What a...
    • Pete_Muller
      Are you measuring from the piston face, or the header mounting face on the back of the cylinder? PM
    • Pete_Muller
      Pete_Muller replied to the thread AFR for dyno..
      I'd say if you have the data channel for it, why not? Can't have "too much" information, IMO. (y)
    • Pete_Muller
      Pete_Muller replied to the thread dap t 50 parts availability.
      If I'm not mistaken, Franklin Motorsports in Wisconsin was the DAP dealer and/or importer waaaaay back. Might be worth a call to them...
    • Pete_Muller
      Pete_Muller replied to the thread Flex pipe storage.
      How about finding a hole saw that cuts a groove that is the right size for flex? Then a series of "holes/grooves" could be cut maybe...
  • Loading…
  • Loading…
Top