Pull 2 washers of cross lowering cross % age, Lower RF camber to 2.6 Neg, Keep rear stagger 1 1/2 "095 chassis 350 and 375 clone
47.2 nose
69.8 cross
59.75 ls
.5 camber lf
2.75 rf
Track width in rear is 39
Kart gets in good center is good but pushes off.. running maxxis ht-3 tight corners 1 1/4 to 1 1/2 rear and 1 1/2 front .. why the push .. 7 and 10 caster
He could maybe run little less nose IF he tweaked other numbers, BUT removing only nose weight will not help, in fact it will make it worse, 47.2 was the nose weight for the Triton so it should be real close.Perhaps you could try to decrease your cross some. i got an 07 Icon and loose on entry and had lot guys tell me increase my cross so im gonna try that. im running clone 375 with 46.5% nose leftside at 58.5 and cross was 62%. i weigh 200. your nose seams tad high to i would try 46 nose .
Ok will do.Pull 2 washers of cross lowering cross % age, Lower RF camber to 2.6 Neg, Keep rear stagger 1 1/2 "
RR should be 1/4 ", LR should be 3/4 " After adjustments If it's good get it on scales confirm numbers, then reset rear track width and rescale to those numbers.Rr cant get your finger in it
Lr is about 2 fingers .
That 4 1/4 and 4 1/2 id where its at now ..Also, I wouldn’t touch washers but that’s just my opinion. Set your LR hub 4 1/4 from cassette. That’s from the edge of cassette to the edge where rim hits hub. 4 1/2 on RR. That’s your track width. Move LR hub out in 1/8” increments if still pushing. The Scythe loves cross so that shouldn’t be a problem.
noTire bite. Kart is stiff and needs bite. Is it rolling the RF and LR edges?
Make 1/8” increments out on LR.That 4 1/4 and 4 1/2 id where its at now ..
OkMake 1/8” increments out on LR.
Cross way to high unless u r on a good biten up track and nose way to high also..to much cross will cause kart push center off..095 chassis 350 and 375 clone
47.2 nose
69.8 cross
59.75 ls
.5 camber lf
2.75 rf
Track width in rear is 39
Kart gets in good center is good but pushes off.. running maxxis ht-3 tight corners 1 1/4 to 1 1/2 rear and 1 1/2 front .. why the push .. 7 and 10 caster
ok ..thanksCross way to high unless u r on a good biten up track and nose way to high also..to much cross will cause kart push center off..
Not if the tires have proper bite in them !!Cross way to high unless u r on a good biten up track and nose way to high also..to much cross will cause kart push center off..