N NMS New member Jan 4, 2014 #1 How can i tell is a rocker is a 1.3 if its not stamped? Also is it ok to run stock push rods and lifters and valves? Thanks
How can i tell is a rocker is a 1.3 if its not stamped? Also is it ok to run stock push rods and lifters and valves? Thanks
J jamiespop New member Jan 4, 2014 #2 NMS said: How can i tell is a rocker is a 1.3 if its not stamped? Also is it ok to run stock push rods and lifters and valves? Thanks Click to expand... The one I have is much shorter.
NMS said: How can i tell is a rocker is a 1.3 if its not stamped? Also is it ok to run stock push rods and lifters and valves? Thanks Click to expand... The one I have is much shorter.
6 65ShelbyClone Member Jan 4, 2014 #3 Measure the distance from the pushrod cup to the center pivot and from the center pivot to the valve end. Divide the valve-side measurement by the pushrod-side measurement and you'll have the rocker ratio.
Measure the distance from the pushrod cup to the center pivot and from the center pivot to the valve end. Divide the valve-side measurement by the pushrod-side measurement and you'll have the rocker ratio.
S subbietjw Member Jan 4, 2014 #4 if you put a 1-1 and a 1-3 side by side you will know!!! the push rod side will look like .100 shorter to the bolt hole... cant miss it!!!
if you put a 1-1 and a 1-3 side by side you will know!!! the push rod side will look like .100 shorter to the bolt hole... cant miss it!!!