I pulled a good pushbutton starter box and coil out today. In the first pic the red wire and single connector goes to the starter lead, the other two plug into the stator, they can only go one place so I am sure you have all that hooked up properly. In the second pic the lead with the eyelet is the ground, that has to be connected to the engine. I noticed in your pics you have a second ground wire attached with the main ground. Is that going into the harness? It looks like somebody has been splicing wires, they may have it hooked up improperly. The third pic is the blue coil, it uses a spade connector instead of a bullet style, but I believe a black coil will work fine if the connector is changed. There is also a braided ground strap that hooks the coil to the clutch cover, the rubber vibration mounts that the coil is attached to do not let it ground properly. I think I can see that strap in your pics. If your wiring is hooked up this way, and it has good spark , fuel and compression it should start right up.