2014 Triton setup help

R

Rogue22

New member
Trying to figure out why my RR tire wears on the inside? Too soft perhaps? I run maxxis with the Ducar motor. Some setup info I got:
F: 46.7% total weight: 425lbs
Lt: 60.1%
X: 65%
LF: +.5
RF: -3
Stagger front 1.5in
Rear 1.25in
Ls: 8lbs psi
Rs: 9lbs psi
just trying to figure out why the inside of the RR wears. All help is appreciated.
Track size is ~.2
 
Have you ever tried higher cross, if not increase it to 68 % + if it ends up at even 70 % leave it just so min is 68 %, see if that helps, if it does but you still have slight more wear on inside of the RR Lower LF pos camber to .25 that will unload the RR slightly more.
 
Rogue22 said:
Trying to figure out why my RR tire wears on the inside? Too soft perhaps? I run maxxis with the Ducar motor. Some setup info I got:
F: 46.7% total weight: 425lbs
Lt: 60.1%
X: 65%
LF: +.5
RF: -3
Stagger front 1.5in
Rear 1.25in
Ls: 8lbs psi
Rs: 9lbs psi
just trying to figure out why the inside of the RR wears. All help is appreciated.
Track size is ~.2
Click to expand...
Up 3-4% cross, down .25 in LF camber. If your RR is still wearing it’s too soft.
 
You must log in or register to reply here.
Back
Top