32mm mikuni alcohol jet size

Are you sure the thing isnt just too big? Bigger bore carb = loss of low end, air goes thru it slower. Most animals I have seen run a 28mm.
 
Jimmy installed the wrong jets in it? That doesn't sound right.
I'd give Jimmy a call and ask him specifically since he built the engine and carb. He would know better than anyone how it should be jetted.
If it's a billet head, you might be able to carry a 32mm carb, but it does sound a bit big to me. Again, I'm not privy to the build specs, so you would do better to contact Jimmy directly.


-----
🏁Thanks and God bless,
Brian Carlson
Carlson Racing Engines
Vector Cutz
www.CarlsonMotorsports.com
Carlson Motorsports on Facebook
33 years of service to the karting industry ~ 1Cor 9:24
Linden, IN
765-339-4407
bcarlson@CarlsonMotorsports.com
 
flattop1 said:
with no other info , except its got the wrong ones i would get some smaller jets.
Click to expand...
Agree with this.

The point most miss when asking for correct jet size for a certain carb, is there are so many variables which can change needed jet size.
Some have been addressed already in this thread. A lot more exist.
Don't expect to get an immediately correct answer from a bulk mailing question.
 
95 shaw said:
Agree with this.

The point most miss when asking for correct jet size for a certain carb, is there are so many variables which can change needed jet size.
Some have been addressed already in this thread. A lot more exist.
Don't expect to get an immediately correct answer from a bulk mailing question.
Click to expand...

I think everyone missed the point here....
 
You must log in or register to reply here.
Back
Top