Any one used the rcp-2 from race city?

My thot on the Cam of the Month is -
unless you have a dyno, and have all the stuff to dial it in,
or are willing to track-test it in a race and possibly
finish worse in a race, it's best to let your
engine builder make cam selection.
 
Last edited:
My thot on the Cam of the Month is -
unless you have a dyno, and have all the stuff to dial it in,
or are willing to track-test it in a race and possibly
finish worst in a race, it's best to let your
engine builder make cam selection.
I don't have a engine guy I doy own work i assumed there had been guys that have used it and could give there input on it say vs the cl3 bsp4 ect ect
 
Far from cam of the month .... it has been out for a few years now. Good cam but just as the others it needs to be set up/installed correctly.
 
I had one. When I called to get the install specs (lift and lash) and they wouldn't tell me, I pulled it and replaced it with a competitors cam that did come with specs. It came with their short block I purchased from them. I didn't think it was too much to ask, guess it was....:unsure:
 
Great green and purple plate cam. 112.5 -113 CL (Best Acceleration Rate I've Tested for Plate Motors)
Zero Lash Cold
Test different valve springs (Nose Pressure is Key!!!!)
Dr Fast Pipe
Dover Carb
 
Back
Top