Anyone ever install...

[spincycle]

A dyno cams fm-an-rr 1.25 to 1 roller rocker assembly on their limited/open/modified animal stock head? Like/dislike? Any issues? Thx! DR

 

[bpoirier]

Yes, I've used them on several motors. They work very well and are solid. I run the base plate without a gasket. I just use RTV silicone on the base plate.

 

[spincycle]

Yes, I've used them on several motors. They work very well and are solid. I run the base plate without a gasket. I just use RTV silicone on the base plate.

Thanks getting one ordered up

 

[spincycle]

Yes, I've used them on several motors. They work very well and are solid. I run the base plate without a gasket. I just use RTV silicone on the base plate.

Did you have to get custom length pushrods to go with it?

 

[bpoirier]

Did you have to get custom length pushrods to go with it?

I measured and made a set of pushrods for the engine. I don't remember if I tried a set of stock pushrods first

 

[CarlsonMotorsports]

I think the stock pushrods worked with them. I was going to go the Comp "make to fit" route too, but ended up the same length so I used the stock ones on a mild build. So far, no problems that I'm aware of.


-----
Thanks and God bless,
Brian Carlson
Carlson Racing Engines
Vector Cutz
www.CarlsonMotorsports.com
Carlson Motorsports on Facebook
www.youtube.com
34 years of service to the karting industry ~ 1Cor 9:24
Linden, IN
765-339-4407
bcarlson@CarlsonMotorsports.com