Yeti Racing
New member
Isn't this OP about Axle s ?
Axelology ? 1 1/4 1.25 vs 1 3/8 1.375 35mm vs 40mm vs 50mm
- Thread starter Yeti Racing
- Start date
alvin l nunley
Site Supporter
only the radius of the turn and the center to center width of the rear wheels.
Just an opinion mind you, but I don't think any of the things you mentioned have anything to do with the stagger. The spreadsheet very clearly states that the calculated stagger is only hypothetical. Not that all the things you mentioned are not important, they are, but my stagger spreadsheet does not address those variables.
From the desk of Al Nunley
Comments compliments criticisms and questions always welcome.
If the data does not support the theory, get a new theory.(Al Nunley
alvin l nunley
Site Supporter
perhaps you haven't noticed, very few threads remain concentrated on the original posters question. I call it thread drift, and it happens all the time, and I'm wondering why the thread drift police even care.
From the desk of Al Nunley
Comments compliments criticisms and questions always welcome.
If the data does not support the theory, get a new theory.(Al Nunley