belt drivers....

spincycle

Member
needing a little education here, been running a kt100 with 30mm belt drive, obtained a parilla 125, thought I could take that same crankshaft pulley and put it on the 125 crankshaft, but I found that the end of the crankshaft on the 125 is bigger than the one on the kt100...where can I get a 21T 30mm belt drive pulley that will fit the 125 crankshaft...and a starter nut as well? Thx!
 
+1 on what moe said. Super mag 7 degree or the standard 5 degree like the ignition side. Go talk to Chris at Hegar, he’ll get you set up. It’s worth the money getting the 3 piece so the hub always stays on!
 
Back
Top