D dsbandit77 New member Nov 9, 2013 #1 stinger clutch and running a bully driver 11 tooth its metal to metal is this a bad idea ? has any one had luck using this combination ?
stinger clutch and running a bully driver 11 tooth its metal to metal is this a bad idea ? has any one had luck using this combination ?
older n dirt Member Nov 9, 2013 #2 We run it on our opens all the time, no problems. But I use a good hard grease between the driver and clutch tube. JMO
We run it on our opens all the time, no problems. But I use a good hard grease between the driver and clutch tube. JMO
older n dirt Member Nov 9, 2013 #4 I'm with you I like the bearing drivers or the brass bushings atleast, and was a little leary of this type of driver at first. If you just keep it well lubed with hard grease you should be fine.
I'm with you I like the bearing drivers or the brass bushings atleast, and was a little leary of this type of driver at first. If you just keep it well lubed with hard grease you should be fine.
D dsbandit77 New member Nov 9, 2013 #5 if you dont mind me asking what type of grease are you using ?
older n dirt Member Nov 9, 2013 #6 I use a automotive type grease like Valvoline # 615 , you can get it at most parts stores.