Burris Threaded tire question

[racing promotor]

Do they require different staggers than slicks ?
Same rear hub spacing ?

 

[flattop1]

Hub spacing should be no different .
They definitely size up different in my experience.

 

[racing promotor]

I figured they end up bigger, but do you need more stagger ?

 

[flattop1]

You get more naturally , from the tires themselves .
Trying to get too one inch is going to require some effort and experimentation.
When we ran them thats all we used , once we switched never needed them .
Can't say as never tried tuning for both .
Though we did run them on the phenom a couple times . Put them on an adjust from there .

 

[95 shaw]

Are you looking for NF or NC sizes?
Maybe metric?

Jk!

Here is a chart with rollouts on rims to give an idea.

https://www.pprkartsupply.com/collections/burris-tires/products/burris_chart

 

[JPMKarting]

I figured they end up bigger, but do you need more stagger ?

For what it’s worth, we usually run 1/2” more than slicks

 

[racing promotor]

Are you looking for NF or NC sizes?
Maybe metric?

Jk!

Here is a chart with rollouts on rims to give an idea.

https://www.pprkartsupply.com/collections/burris-tires/products/burris_chart

Actually have no clue asking for someone else that rule changed from slicks only to treads only, was trying to confirm what to expect in general with set up, but thanks for the info.

 

[racing promotor]

For what it’s worth, we usually run 1/2” more than slicks

That's what I was looking for.
Thanks

 

[CarlsonMotorsports]

This really depends on the size tires you choose to go with. If you go with the bigger tires, you will need (and easily get) more stagger. If you run smaller right sides, you can keep them small and run the exact same stagger as you do with slicks.

We do these tires all the time (as well as Hoosiers) for classes/tracks that mandate treaded tires only.
We also offer custom mounting, sizing, cutting, finishing, prepping, and balancing of treads.

-----
Thanks and God bless,
Brian Carlson
Carlson Racing Engines
Vector Cutz
www.CarlsonMotorsports.com
Carlson Motorsports on Facebook
31 years of service to the karting industry
Linden, IN
765-339-4407
bcarlson@CarlsonMotorsports.com

 

[ohv60racr]

For what it’s worth, we usually run 1/2” more than slicks

Is that both front and rear JP ?