camber settings for microstock.

flytes racing

New member
anyone got some camber setting suggestions for a 1/8 dirt track not alot of banking to it. L block i have. microstock 206. rear engine and should i check the camber settings off the ground or on level ground when adjusting?? pushing really hard going into the corner wont steer.
 
Last edited:
Camber/toe/caster should be checked and set on level ground with the driver
in the kart suited up and everything ready to run. This will take into account all the
potential flex thruout the chassis.
Pushing (I'm hearing - You turn the steering but the kart doesn't turn) is the front tires
not connecting with the track well enough to turn.
 
What chassis? What is their recommended base line setup for caster/camber? Most karts are running +.5 on LF and -2.5* RF
 
What chassis? What is their recommended base line setup for caster/camber? Most karts are running +.5 on LF and -2.5* RF
i have no idea what this chassi is. all i know is i think its from the 90's but the person used square tubing for the frame. instead of round. just about 8 foot long 4 foot wide rear engine. with side rails on.
 

Attachments

  • 53316590_827892947563199_6345660231032242176_n.jpg
    53316590_827892947563199_6345660231032242176_n.jpg
    86.4 KB · Views: 32
Back
Top