I am considering putting one of my karts on the jig table and updating the front end. My question is spindle elevation. Is it supposed to be along the same plane as the rear axle in comparison to the frame rails?
It cant be too much of a secret bc they are all the same other then the amount of adjustability. Maybe this isnt the correct forum. If I make the axle and spindles on the same plane, then put smaller tires on front, this will provide negative rake. Is there a majic number or range?
It cant be too much of a secret bc they are all the same other then the amount of adjustability. Maybe this isnt the correct forum. If I make the axle and spindles on the same plane, then put smaller tires on front, this will provide negative rake. Is there a majic number or range?