Clutch Identity Help

I'm unable to upload the pictures I took as they are too large for the forum. I had a two disk clutch come into the shop yesterday that had a top plate 12 ball bearings roughly 1/4" in diameter held in with clips, these appear to somehow press the pressure plate to engage the clutch. The disks are 4 tab, had a red aluminum basket with a Bully style driver. Anyone have any idea what it is?

Since I can't upload a picture, here is how the clutch is assembled:

TOP PLATE
BALL BEARINGS
PRESSURE PLATE
DISK
FLOATER PLATE
DISK
BACK PLATE
 
That would be an original SMC clutch.

Used a coated ball resting in a teardrop slot in the pressure plate restrained by tension clips. Adjusted by airgap, clip height, and clip thickness.

Required a lot of attention to work properly.
 
That would be an original SMC clutch.

Used a coated ball resting in a teardrop slot in the pressure plate restrained by tension clips. Adjusted by airgap, clip height, and clip thickness.

Required a lot of attention to work properly.

This is why Bob's is the best, thanks! I had searched all over trying to figure out what that clutch was. Been around karts 19 years and never seen one.
 
Back
Top