degree wheel

kartboy63

Member
when installing a degree wheel, should the numbers face outwards or towards the flywheel so that when you turning the flywheel you can see the number, or does it matter what way it faces
 
It does not matter ,face the numbers in the direction that makes your work the easiest,I used a large wheel so it had to hang over the edge og the bench, so numbers faced out.
 
Here's an example for you that we use...............this is for the Honda 160, but would be the same for the clone.
Cam profile check - Honda.JPG
 
Don, I have a file of a degree wheel that is cut at + or -60°. It should print on an 8 x 10 piece of paper. It has a 6 inch radius so if printed full-size it would be 12 inches round.
12 cut degree wheel.jpg
 
Back
Top