Dual bearing crank in a single bearing block?

J

JKF66

New member
Blew up my dual bearing block. Is it possible to use the same crank in a single bearing block just by removing the flywheel side bearing? If so, how do I get the bearing off? Crank is tricked out for a modified.

Thanks
JKF
 
Just knock the bearing off with a hammer .I normally pull it off if I'm planning on re-using the bearing .Yes you can use the crank in either type block.Several years ago, I did see some old Horstman stroker shafts that had a larger taper on the flywheel side, that took a little machine work to use in a bearing block.
 
You must log in or register to reply here.
Back
Top