Dual engine mounts

Can you send me pics we got to get the spacing right first and that’s been a problem with the ones people are selling.
Here are the dimensions:
The engine mounting plate is 3/4" thick.
The measurement between the engine mounting slots is 4 13/16".
The slots are 4 5/16" on center and they are 7/16" wide by 2" long.
It uses a 8mm x 40mm cap screw with a 3/8" diameter by 3/4" long sleeve with the cap screw to hold the engines to the plate.
The mount is setup for 1 ¼” frame rails by 3 3/8” on center.
Let me know if there is any other measurements that you need.

I'm asking $450.00 for it and I also have a 1" Bully Turbo clutch to sell for $200.00 plus shipping

20201116_111150[1].jpg

20201113_141602[1].jpg20201113_145405[1].jpg
 
What engines are you looking to mount? I do know Reedjet barrels are wider than TT75's and require more room.
Here is the first one I built, it mounts the engines fixed and uses tensioners to adjust the belts.
 

Attachments

  • 009 (4).JPG
    009 (4).JPG
    68.6 KB · Views: 28
Last edited:
I mounted it to a Legend SS chassis with this. I never had any issues with the mount, only the chassis flexing. Keeping the chain on was a task. Hooked up on the throttle the chassis would flex too much and pitch the chain.
 

Attachments

  • 018.JPG
    018.JPG
    81.8 KB · Views: 68
  • 003 (5).JPG
    003 (5).JPG
    62.2 KB · Views: 68
  • 005 (5).JPG
    005 (5).JPG
    56.2 KB · Views: 68
Back
Top