engine off of Generac pressure washer ??

xtratoy

Member
I picked up an engine off of a Generac pressure washer. Not sure of the maker of motor. Only 2 ID labels on it. It says it is a 216cc engine. The output side of the crankshaft is tapered from 1.1" down to .815" and the taper is roughly 1 5/8" long. The carb is mounted to an elbow that sweeps upward. Is there any clutches that would fit this style of crankshaft?
 

Attachments

  • 20201108_105755.jpg
    20201108_105755.jpg
    113.4 KB · Views: 23
  • 20201108_105707.jpg
    20201108_105707.jpg
    71.2 KB · Views: 25
  • 20201108_102755.jpg
    20201108_102755.jpg
    107.7 KB · Views: 26
Generac made their own engines in Wisconsin before they were bought out by Briggs. I have never heard of any centrifugal clutches for tapered shafts.
 
It's a Generac GN220 engine. Going to be very difficult to find parts for. The OEM sourcing was getting very thin 15 years ago, probably close to nonexistent now. I have several of these engines put up on a shelf, everything for high performance would have to be custom made.
 
Back
Top