Jimbo
You can fool some of the people some of the time
If you are tired of dealing with the frayed ends of your throttle cables here's a tip for you!
Take a 1" long piece of 1/4" copper or brake tubing and put it in a vice and pinch the end shut
Use a propane torch to melt some solder into the tubing.
Take the end of your throttle cable and dip it in some soldering flux paste and then into the molten solder inside the tubing.
When you remove the cable shake the excess solder off.
If the cable is on the kart already just hold the tubing with a vice grip and do the procedure right on the kart.
Keep the propane torch away from the fuel tank and anything else that's flammable!!!
If the cable is already frayed you can carefully remove those strands with the bench grinder before or after soldering.
Take a 1" long piece of 1/4" copper or brake tubing and put it in a vice and pinch the end shut
Use a propane torch to melt some solder into the tubing.
Take the end of your throttle cable and dip it in some soldering flux paste and then into the molten solder inside the tubing.
When you remove the cable shake the excess solder off.
If the cable is on the kart already just hold the tubing with a vice grip and do the procedure right on the kart.
Keep the propane torch away from the fuel tank and anything else that's flammable!!!
If the cable is already frayed you can carefully remove those strands with the bench grinder before or after soldering.