Intrepid ride height


New member
Hi there,
I'm relatively new to karting. I have an Intrepid chassis and would like to adjust the ride height. One would assume there would be a lot of documentation on youtube, etc for this kind of stuff but I haven't found any that provide clear step by steps guides on how to do this.

Anyone else have the same problem and how do you deal with it?



Dawg 89
Not sure what the problem is .
At the rear the typically are sets of holes too raise or lower the axle thus raising or lowering the chassis .
In front your spindles should have some adjustment via washers or jack bolt if so equipped . There is not a lot of height adjustment 3/4 " max .