Jet too small?

Hoonigan

Member
Not sure what size jet is in it but my clone will not run with the choke wide open..only cracked about 2/3rds open? Suggestions?
 

OVALTECH1

Site Supporter
Carb needs tore down and thoroughly cleaned. Make sure you clean all the air bleed holes out and low speed jet as well.
 

OVALTECH1

Site Supporter
Need to know a few things about motor and carb. What’s all done to motor? Is it plate or unrestricted? Does it have the correctly calibrated metering for your application? Finally pull the jet a lot are marked if not pin gauge it and get the size.
 
Top