K35 stuffer: CAD model

Pete_Muller

Moderator
OK, here is another CAD model: I created this recently for a some friends because the K35 stuffers are getting more difficult to find. (mainly for the vintage racers running B-Limited or C-Open).

This was created in Fusion 360, and I 3d printed this model and sent it to Steve O'Hara who checked it for fit in one of his K35 engines.

Note that this model is not "shelled out" from the flat face side. The stock/IAME stuffer has some small ribs running crosswise (essentially between the mounting holes), and has a good bit of material removed in that area (stock IAME part is cast aluminum). I didn't put this feature in because if I was going to machine them myself, my plan was to just sink a couple of tapped holes into that area so I had an easy way to hold the part while it was profiled from the other side. I can modify this model if someone has a special request.

CAD model (STEP format) here --> https://www.dropbox.com/s/vxj6u00relert98/K35_stuffer.zip?dl=0

PM


K35_1.jpg



K35_2.jpg
 
Back
Top