What I'm looking for are ones made to fit the wide split frame rail design on the 2018 Minecon....I've got a set of them that are for older style 1 1/4" standard frame rail width....Let me check my stuff. I might have an old set that fit 1-1/8" rails & might need the 1-1/4" stuff for my karts.
Maybe a trade?
Brian #89
Oh, ok. How wide are your 2018 Minecon rails?What I'm looking for are ones made to fit the wide split frame rail design on the 2018 Minecon....I've got a set of them that are for older style 1 1/4" standard frame rail width....
Already spoke to Buller...they're so far behind on filling clutch orders right now, they are not doing anything with producing anything until they are caught up, estimating that to be maybe 3 months from now....If you take it to a local machine shop, they should be able to fix you up. 1" stock, duplicate the angle on one end each, then duplicate the length, then add the saddle on one side, and a flat on the other. Use more 1" stock to make the butterflies. I'd probably charge $100 for it. This is the danger in buying "odd" (non-standard) stuff -- everything has to be designed around it. My first thought would be to call Buller and see if they have some odd ones laying around that would work. I don't have a mill (at the moment) but this is the kind of project I enjoy doing. Good luck!
That's a thought....I'll look at it closer this weekend and see if there's anything to work with there....thx! DonCan you bolt the jackshat assembly to your existing mount base ?
It might raise it up a little , which could help with pipe clearance if going two stroke .
Picked up a nice 131 I'm itching hard to get on the kart and race...Can you bolt the jackshat assembly to your existing mount base ?
It might raise it up a little , which could help with pipe clearance if going two stroke .
PRC 4cycle mount base won't take the jackshaft base plate unless significant modifications are done to it, and it's already designed to be fairly lightweight, removing any more of it's material would leave me very skeptical that it would hold up to the weight of the engine and the forces on it during race conditions....guess I'll just wait till maybe buller can make one for me....That's a thought....I'll look at it closer this weekend and see if there's anything to work with there....thx! Don
Thanks for the thought, got messages in to both, we'll see if they can help....DonSpin you might try Comet Kart or TS Racing either one may have what you need. later Chuck..