Need help with 2014 Trtion

C

Connor_05

New member
Kart is loose apex off no corner speed

Driver total weight 403
C - 66%
L - 59.3
N - 46.4
Right Camber 2.75
Left Camber .05
XL Seat 3 1/2 off motor rail
Seat 9 inches off axle
Stagger 1 1/2 front 1 1/8 rear
Running 8 1/2 left rear tire
Maxxis Tires
Gear - 17/81 219 Chain
Castor 10-13

1/8th mile dry/dusty low bite track and very little banking
 
Connor_05 said:
Kart is loose apex off no corner speed

Driver total weight 403
C - 66%
L - 59.3
N - 46.4
Right Camber 2.75
Left Camber .05
XL Seat 3 1/2 off motor rail
Seat 9 inches off axle
Stagger 1 1/2 front 1 1/8 rear
Running 8 1/2 left rear tire
Maxxis Tires
Gear - 17/81 219 Chain
Castor 10-13

1/8th mile dry/dusty low bite track and very little banking
Click to expand...

Could use a bit more nose, maybe a bit less left but the numbers arent that far off. I am going to say its tires, a prep issue.
 
Only 1 1/8th stagger on a 1/8th mile. I'm no expert but you might not have enough stagger which will hurt your entry going in and by time the kart turns it breaks loose. I could be wrong... I'm curious to hear the other suggestions
 
Connor_05 said:
Kart is loose apex off no corner speed

Driver total weight 403
C - 66%
L - 59.3
N - 46.4
Right Camber 2.75
Left Camber .05
XL Seat 3 1/2 off motor rail
Seat 9 inches off axle
Stagger 1 1/2 front 1 1/8 rear
Running 8 1/2 left rear tire
Maxxis Tires
Gear - 17/81 219 Chain
Castor 10-13

1/8th mile dry/dusty low bite track and very little banking
Click to expand...

Get up on your RF camber, especially with 400 lbs. I'd run -3.25 on the RF. It'll help with your corner speed and looseness all in one adjustment.
 
We have the 2013 triton and race a track that sounds a lot like your track. We had to raise the seat to raise vertical height to get more bite. Mop the tires with black sand prep and increase rear stagger. That seamed to get us hooked up pretty good when my son don't over drive!
 
You must log in or register to reply here.
Back
Top