Backyardkarter
New member
Hello.
Im a new karter with a year under my belt. We just run back yard tracks. We have 2- 1/8 mile tracks. One that tends to be hard pack with moderate grip. And one thats tacky lots of bite. Oregon weather temps from 80 to 100 dag.
Current chassis is Jackyl, far as I can tell its an older prc clone cant find any info. Used set up chart from older nemesis.
Camber LF -.25 RF +2.60.
Caster. LF 5 RF 8.
Running burris ss-11 LS 11x6x6 and burris ss-22 RS 11x8.10x6. Have a set of Maxxis pinks 11x6 and 12x9 that I havent ran yet. My right side inner rims are matched , left side outers matched and set 1/2 from frame. Running from 6 to 8psi on right and 4 to 7psi on left.
I currently dont have a way to scale it.
Entering in a corner has a slight push then grips but, lose a ton of speed or have to brake check,to set the kart. Can't find any info on where to reset my washers for my spindle heights,which look like PRC type spindles.
Any advice would be greatly appreciated. Hopefully there is enough info here.
Im a new karter with a year under my belt. We just run back yard tracks. We have 2- 1/8 mile tracks. One that tends to be hard pack with moderate grip. And one thats tacky lots of bite. Oregon weather temps from 80 to 100 dag.
Current chassis is Jackyl, far as I can tell its an older prc clone cant find any info. Used set up chart from older nemesis.
Camber LF -.25 RF +2.60.
Caster. LF 5 RF 8.
Running burris ss-11 LS 11x6x6 and burris ss-22 RS 11x8.10x6. Have a set of Maxxis pinks 11x6 and 12x9 that I havent ran yet. My right side inner rims are matched , left side outers matched and set 1/2 from frame. Running from 6 to 8psi on right and 4 to 7psi on left.
I currently dont have a way to scale it.
Entering in a corner has a slight push then grips but, lose a ton of speed or have to brake check,to set the kart. Can't find any info on where to reset my washers for my spindle heights,which look like PRC type spindles.
Any advice would be greatly appreciated. Hopefully there is enough info here.