Orangeshovel
New member
Bout to start putting together a stroker open animal(gen5).
Thinking about using:
2.437 billet stroker crank
3.625 billet rod
2.756 piston
If i use the +.237 crank would a .340 lift cam or the .400 lift cam be better? Is the .400 too much? Also depending on which cam i decide what would be a good idea for porting and valve size? increase intake or exhaust or both? With that much lift what head would be best? Could i use a WF head or should i just find an aftermarket head?
Also are there any other stroker cranks for the animal besides the +.237 crank?
For this setup is roughly +.080 overbore enough?
Thinking about using:
2.437 billet stroker crank
3.625 billet rod
2.756 piston
If i use the +.237 crank would a .340 lift cam or the .400 lift cam be better? Is the .400 too much? Also depending on which cam i decide what would be a good idea for porting and valve size? increase intake or exhaust or both? With that much lift what head would be best? Could i use a WF head or should i just find an aftermarket head?
Also are there any other stroker cranks for the animal besides the +.237 crank?
For this setup is roughly +.080 overbore enough?