B buckshot35 Member May 23, 2021 #1 want to put the Prc Press in studs in aftermarket hubs any one know what drill size to use?
flattop1 Dawg 89 May 24, 2021 #2 I Think they need the serrations pressed in too start . If I was gonna do it . two ways . first measure the stud/bolt then choose based on that . 2nd a good pin punch and hammer . It will likely be a one time deal .
I Think they need the serrations pressed in too start . If I was gonna do it . two ways . first measure the stud/bolt then choose based on that . 2nd a good pin punch and hammer . It will likely be a one time deal .
flattop1 Dawg 89 May 25, 2021 #5 buckshot35 said: just want to see if it is possible to do. Click to expand... Unless the hubs stripped out . Theres no benifit . Even then it's a band aid fix till a replacement was obtained .
buckshot35 said: just want to see if it is possible to do. Click to expand... Unless the hubs stripped out . Theres no benifit . Even then it's a band aid fix till a replacement was obtained .