Recoil slips

Kman1771

Member
I had a recoil slip on my clone so I changed it. I used a new recoil from a predator and it slips. What would be causing both to slip ?
 
I guess the hub is what is left. Edit: is the predator a direct swap with clone? I have not worked on a predator.
 
Last edited:
Take the recoil assembly off, pull the cord. Do both dogs stick out when spun? If so, is the starter cup in good shape where the dogs extend into it? Is it tight? Flywheel nut not backing off and the nub on the back of the cup hasnt worn off and is just spinning?
 
Last edited:
Take the recoil assembly off, pull the cord. Do both dogs stick out when spun? If so, is the starter cup in good shape where the dogs extend into it? Is it tight? Flywheel nut not backing off and the nub on the back of the cup hasnt worn off and is just spinning?
My guess is the same.
This is what happens from over pulling one to start it
 
Back
Top