Al, show them one of your drawings that show that the lifting of the rf is simply the normal effect of positive caster. In fact a bend in a frame or spindle cannot change this. All of you need to get back to the basics of kart front end geometry.Not ruling out a bent spindle, but what about the frame?
Remove both front tires and spindles. Both rear tires. Set kart on a flat surface. The garage floor should work just fine. Measure the height of the spindles. Any difference would indicate a bent frame.
I just remembered the very informative diagrams you so generously shared with all of us.So, You're Familiar with this kart also? Strange that you both rule out a bent frame? Sounds like you don't even want to check it!
Maybe you should go back and read post #10. After you do, maybe you could post an apology for getting on my case with no justification!!I just remembered the very informative diagrams you so generously shared with all of us.
I am not doing anything of the sort, I enjoy your thoughtful posts and many here could learn from them if they approached them with an open mind. I assume you must have thought my prior post was sarcastic, it was not, my intent was to be respectful.Maybe you should go back and read post #10. After you do, maybe you could post an apology for getting on my case with no justification!!