Running a Predator billet rod in a clone

racerdad

Member
Is the sizes close enough on both ends. I'm looking at the Hemi one, but are the both the same, hemi and non hemi?
 
So the Predator bearing is just a thinner bearing than the clone bearing? Clone crank is 1.178 journal and the 212 is 1.188. Theres a reason why they have 2 different part numbers for these bearings.
 
So, I would have to get a clone bearings and the predator rod. I want the predator length, 3.308. Looking at dyno cams, the ducar 212 billet rod from ARC is that length and has a crank pin size of 1.181, closer to a clone. Could that work
 
Is there a reason why you wouldnt run a clone rod? 3.303 stock length or the 3.313 clone rod, which is .010 longer than stock?
 
Wanting the .005 longer, 3.308. We're told a hemi predator is the right one, but not from my research. Just kinda verifying my research
 
Back
Top