J JasonRacin New member Sep 19, 2023 #1 How to shrink the expander ring for std piston clone. I know you can cut it but is there a way to shrink
How to shrink the expander ring for std piston clone. I know you can cut it but is there a way to shrink
R rmvasko Member Sep 19, 2023 #2 I may be old school but taking a little bit of material off of each Edge of the expander works for me if it's not broke don't fix it
I may be old school but taking a little bit of material off of each Edge of the expander works for me if it's not broke don't fix it
J JasonRacin New member Sep 20, 2023 #3 It actually needs more than that to get the right size so it's not tight. The dyno cams low tension works but I was trying to do myself
It actually needs more than that to get the right size so it's not tight. The dyno cams low tension works but I was trying to do myself
1fasttiller Member Sep 20, 2023 #4 You'll need an iron sleeve sized accordingly and a torch, get it red hot and it will shrink and lose tension.
You'll need an iron sleeve sized accordingly and a torch, get it red hot and it will shrink and lose tension.
OVALTECH1 Site Supporter Sep 20, 2023 #5 ^^^ this ! There’s more to it than just cutting it undersize.
DynoDon Moderator Sep 20, 2023 #6 Cut it until you have 3.5 lbs of drag on the piston with a fish scale. No need for heating