D
Deleted member 21174
Guest
We have a 30mm (3mm thick) axle that was in good shape till it snapped during racing going into a sharp hairpin. It broke off between the wheel and the bearing on the motor side in an area that was in great shape and never used for set screws etc
Could this be setup related? Maybe the kart is too tight? I know the LO206 is a torque-y motor but this seems ridiculous.
I am not sure if I should add caster to get the inside wheel to lift, or take out caster to "free" up the kart and make it easier to push through the turn. Or maybe this is just normal wear and tear?
Could this be setup related? Maybe the kart is too tight? I know the LO206 is a torque-y motor but this seems ridiculous.
I am not sure if I should add caster to get the inside wheel to lift, or take out caster to "free" up the kart and make it easier to push through the turn. Or maybe this is just normal wear and tear?