I have a 2007 Slack Reactor chassis. Running Sr. 350# pro clone on a 1/10th mile clay oval. Track has a lot of bite in both heats and feature. have tried hoosier d-20's as well as yellow vegas. Running a select seat 9-1/2" from axle centered on brake rotor. Driver is roughly 240lbs. takes off ok but falls to the back quickly. I got in the kart and drove it and the kart seems awfully tight. tough for me to diagnose as I'm running opens with some power but ran flatheads for many years prior. turning hard left feels like its glued to track. my setup is the following. minus caster as there are no degree markings.. not sure if correct there. pin in front on rf L-block. I believe its 8 on left and 12 on right.
Camber is +5 left and -2.5 Right
toe is 1/16th out
tires are at 6 psi right side and 5psi left
nose 46.5
left 57-58 window
cross 61-63
right side is squared up close to frame rail on left rear 1/8" to 1/4"
39" track width.
Any help in what to do to help this thing..?
Matt Field
Camber is +5 left and -2.5 Right
toe is 1/16th out
tires are at 6 psi right side and 5psi left
nose 46.5
left 57-58 window
cross 61-63
right side is squared up close to frame rail on left rear 1/8" to 1/4"
39" track width.
Any help in what to do to help this thing..?
Matt Field