Throttle linkage

I have a predator 212 and I put a top plate on it and I have a throttle rod on it to the carb. The throttle rod will bounce around when idling and I need to figure out how to keep it in the black throttle shaft on the carb. Can I bend it to keep it in there? Any better ideas?
 
We wire tie ours if we’re talking the same spot. I’ll post a pic later or if you can post one
 
C26AB0E5-EDA6-4491-A612-A44A941A1399.jpeg

Not sure if that’s where your talking about or not ?
 
Back
Top