Valves

I have replaced valves on a couple clone heads and usually just order off BSP. They have not been the stainless ones and i can see some rust on the exhaust valve after some use and sitting in the garage. Are the valves from builders noticeable better flowing and/or hold up better than the ones you get from these guys? If so who is a good source?
 
Our findings.. The stainless we have gotten in the past and paid more for were just not up to par.. They had more issues burring up on the retainer pad area..When thats happening you start loosing spring tension little by little.. Theres some good Nitrite Coated Valves that most of the shops sells that are as good as you need at lesser cost..
 
Our findings.. The stainless we have gotten in the past and paid more for were just not up to par.. They had more issues burring up on the retainer pad area..When thats happening you start loosing spring tension little by little.. Theres some good Nitrite Coated Valves that most of the shops sells that are as good as you need at lesser cost..
Jerry, are these valves sold on your site? Great info, thank you.
 
Back
Top