54 % left, 46.5 % nose, 59% cross, 2.5 Rf neg camber, .5 Lf Pos camber, Inside RR wheel 3/16" from cassette hanger, Lr Inside of wheel to hanger 7/8 ",
Set chassis on flat table set seat on triple thickness of cardboard about 1/4 " to 3/8 ", front center seat 1/2 " right of post, rear seat spline 1/4 " right of break rotor, rear of seat back at top 9.5 " off top of axle, Square Right side toe Left out 1/8 ", 1.5 " front stagger, 1 1/8" to 1 1/4 " rear stagger. All weights high on seat sides, in nose if needed, If needed 10lb could be two third up seat back, use big fender washers against seat inside an outside.
Good Luck !!