Camber change

[Packman88]

Been having my camber fluctuate between races we scaled last week I had rf at -2.25 , just got on scales after racing , and rf is at -3.00. Scales are level, same place as always on floor, and stands, same air pressure etc. Is this normal ? I'm thinking its not but it did it to me last week as well

 

[racing promotor]

Have you checked the hub and king pin bearings , check make sure the heim threads aren't stripped

 

[Pops90]

Been having my camber fluctuate between races we scaled last week I had rf at -2.25 , just got on scales after racing , and rf is at -3.00. Scales are level, same place as always on floor, and stands, same air pressure etc. Is this normal ? I'm thinking its not but it did it to me last week as well

Did your stagger change?

 

[flattop1]

Same tires ? One tip put the valve stems down each time .
Lift the kart after adjustments .
Toe lock can move .
2.25 to 3 is a concern .

 

[Packman88]

Have you checked the hub and king pin bearings , check make sure the heim threads aren't stripped

Hub bearings are new, king pin bearings seem tight

 

[Packman88]

Same tires ? One tip put the valve stems down each time .
Lift the kart after adjustments .
Toe lock can move .
2.25 to 3 is a concern .

Same tires, we as mentioned below , our stagger may have changed a little but I don't think enough it would cause that

 

[Packman88]

Have you checked the hub and king pin bearings , check make sure the heim threads aren't stripped

Starting to wonder about my heims, I seem to have a little trouble with them

 

[racing promotor]

Starting to wonder about my heims, I seem to have a little trouble with them

Unless the spindle shaft got bent, I'd he looking real close at the heims

 

[T-roy]

I got to the point where I scale and check all those things with the tires we will be running the feature with. The ones we PLAN to use anyway. We had a kart that would do similar to that. Was not that extreme and was not a PRC chassis.