Track Tac

Clone break-in

T

TritonJrBluePlate

Member
Does anyone know a good jet setting for a clone to break it in. I want to let it run for about 30~45 to help break it in and don't want it to foul a plug.

This is just a motor for scuffing tires or running a local event at a dusty track.
 
Solder one shut drill to suit. You won't likely be on the main any way unless running 1/2 throttle or more .
Depends on the break-in scenario .
IE: Loaded or un loaded.
 
Last edited:
flattop1 said:
Solder one shut drill to suit. You won't likely be on the main any way unless running 1/2 throttle or more .
Depends on the break-in scenario .
IE: Loaded or un loaded.
Click to expand...
I let it idle for two 30 minutes periods with oil changes after each one. Then ran 10 minutes with a little more throttle. Changed the oil again and just going to let it rip tomorrow. Hopefully it won't lock up.
 
You must log in or register to reply here.
Back
Top