I'll probably just make one with 1/8 inch plastic for the back half. Thanks for lookingJP mine doesn't have one either.
I have a sheet of plastic laying around that I will try to make one from. Try. I was never good in art class.I'll probably just make one with 1/8 inch plastic for the back half. Thanks for looking
Thank you! I'll look him upJeff stiffie ( stiffies clutch’s) makes rear universal ones that you cut to what you need. He’s on the book page.
I make ours out of 1/8" abs plastic without any issues.I'll probably just make one with 1/8 inch plastic for the back half. Thanks for looking
they are universal for most karts or just specific manufacturer??Here is what I just got from Stiffie clutches ( Jeff Rathfon) for my slack pursuit champs. They are universal.
Universal. You just clamp them up to the bottom of your frame. Mark them with a silver or white marker. Trim and make sure you leave enough to tuck up under your front pan. I’m gonna try to make a video.they are universal for most karts or just specific manufacturer??
I would greatly appreciate that if you couldUniversal. You just clamp them up to the bottom of your frame. Mark them with a silver or white marker. Trim and make sure you leave enough to tuck up under your front pan. I’m gonna try to make a video.
If you are going to the OVKA swap meet Halbert Kart Shop may have a full pan like that you cut down.. Halbert will be at OVKA..they are universal for most karts or just specific manufacturer??
I sure am going all check it out thanks a lotIf you are going to the OVKA swap meet Halbert Kart Shop may have a full pan like that you cut down.. Halbert will be at OVKA..
YesIf you are going to the OVKA swap meet Halbert Kart Shop may have a full pan like that you cut down.. Halbert will be at OVKA..
how much difference does a full floor pan make?
Lol trying to decide if i should put one on our micros and juniors.If nothing else it's a handy place to lay your tools while working on the kart.