Info about this cam needed CL-M

[monsterclone]

Good day .could anyone identify this cam for me ? Bought it a time back . Don't remember anything about it. .tia

 

[XXX#40]

That was a very early Minus lift cam, made by Dyno.
Same as the CL-1
https://www.dynocams.com/item/cl1-m/cl-stock/

 

[monsterclone]

Ohhh. And i thought it was like a mod caM , so actually i xan throw it away

 

[monsterclone]

Any info comparing the Bsp cam against the BSP -2 cam and the Ci i i think ? for sprint racing ,rpms goes as high as 6500 and as low as 2500 in corners

 

[race'n junky]

Any info comparing the Bsp cam against the BSP -2 cam and the Ci i i think ? for sprint racing ,rpms goes as high as 6500 and as low as 2500 in corners

All info on Dyno Cams is published on there web site for anyone to compare....
*************

 

[flattop1]

As a general rule -2 means retarded 2 degrees . Retarded favors higher rpm .
Im thinking generally 200 rpm per degree .

 

[monsterclone]

As a general rule -2 means retarded 2 degrees . Retarded favors higher rpm .
Im thinking generally 200 rpm per degree .

Do you think a 1.3 ratio rocker will work with this cam ? With 18 lbs springs .and what degree do think will work with the arc alum flywheel ?

 

[flattop1]

Apparently not a stock rule set .
Yes . 34*-36*
Obviously you need too verify clearance's for yourself. Never assume.

 

[monsterclone]

Apparently not a stock rule set .
Yes . 34*-36*
Obviously you need too verify clearance's for yourself. Never assume.

Its a local stock appearing class . Nothing crazy.thanks for the input

 

[DD83]

Its a local stock appearing class . Nothing crazy.thanks for the input

THESE ARE DEFINATLY NOT THE CAMS TO USE FOR A STOCK APEARING CLASS

 

[kartboy63]

you wont make much power for SA with them cams