Intake manifold for HR Tilly

[Outlaw]

Who makes a intake manifold for a HR Tilly that will bolt up to an animal head?
Thanks

 

[mikelavite#72]

i would check with Clements or VKE . you should ask about the Mikuni SBN asthe carbs have the same mounting footprint

 

[Minidragbike]

No one makes it, it will have to be fabricated.

 

[mikelavite#72]

i have the 2 part intake from VKE for my engines it works for bolth HR Tilly and SBN . i have seenguys use just the half the carb bolts to , and fab up their own part that bolts to the head . it could be done with minimal efforts ....

 

[ske-outlaw17]

agree with mike. I have a few of the intake runners from the dual port adapters and it would be easy to make an adapter

 

[Minidragbike]

Check this out

Check out this item I found on eBay: http://pages.ebay.com/link/?nav=item.view&id=271397883595

 

[PD Power]

Who makes a intake manifold for a HR Tilly that will bolt up to an animal head?
Thanks

It is undesireable for the manifold to taper to a smaller inlet on the head than the carb outlet. This tapers the manifold
down, which would be better served being straight inside, or tapered larger, carb to head.
An angle of 7 degrees larger, from carb to head is a good number to work with. The opposite taper presents a very large downside.
.......PD

 

[mikelavite#72]

agree with mike. I have a few of the intake runners from the dual port adapters and it would be easy to make an adapter

did i get a Gold Star for this post !?!?!?!?

 

[ske-outlaw17]

silver! not a gold fan

 

[mikelavite#72]

silver! not a gold fan

niether are our athletes in the olympics so far