Need a Briggs 5HP crankshaft

[Flathead Builder]

I'm in need of a decent crankshaft that is still within specs for a project I am doing. It is for a 5HP Briggs Model 130202.
This is the style that does NOT have a bearing(s) pressed unto the crankshaft. The crank journals ride directly in the block and side cover bored holes. If you have one to sell please email me directly at michael.moore@charter.net
Thank you,
Michael

 

[flattop1]

What are the specs required. I may have some .

 

[Colt sr]

I may have 1 I just removed from a single bearing block. If that is the type you need.

 

[Flathead Builder]

What are the specs required. I may have some .

"Reject" specs from the B & S Repair Manual:
Crankpin= .9963" or less
Mag/Flywheel side journal = .8726" or less
PTO side journal = .9976" or less
If you have 1 or 2 to sell that is within specs, please send photos to my personal email at: michael.moore@charter.net
Thank you,
Michael

 

[Flathead Builder]

I may have 1 I just removed from a single bearing block. If that is the type you need.

The crank I need does not have a bearing on either end. The journals ride directly into the holes in the block and sidecover.
Thank you,
Michael

 

[Victor mercado]

I think I have one tomorrow I can check text me 7874149649

 

[Flathead Builder]

I think I have one tomorrow I can check text me 7874149649

Hello Victor,
I sent you a private message.
Thank you,
Michael

 

[teamv]

I'm in need of a decent crankshaft that is still within specs for a project I am doing. It is for a 5HP Briggs Model 130202.
This is the style that does NOT have a bearing(s) pressed unto the crankshaft. The crank journals ride directly in the block and side cover bored holes. If you have one to sell please email me directly at michael.moore@charter.net
Thank you,
Michael

 

[teamv]

Delete