Dawg Thread 2

Happy 4th everyone, I can't think of a better way to spend it
 

Attachments

  • 20210703_200423.jpg
    20210703_200423.jpg
    176.5 KB · Views: 9
Safety First Dawgs .
Using my angle grinder one handed with a wire wheel .
As i clean the putty knife up .
I think too myself , You need to put the gaurd back on here .
Bam the putty knife catches slings it in to my hand .
Knowing it hurt , sure enough . I'm leaking red stuff .
Luckly a couple knicks , no sewing needed .. :)
 
Wow tony looks like we both had some angle grinder problems this weekend. I was using a death wheel on the cordless Milwaukee cutting some aluminum bar stock. Trying to make hoops for some fenders/splash guards for the minibike. Was about 3/4 of the way through and wheel shot apart and hit me in the leg. Luckily it bounced off and no red stuff was spilled. Still scared the 💩 out of me. I had even picked up the grinder looking at the wheel knowing darn well I should've replaced the wheel.
 
Funny thing . My neighbor sheared a key on his boat engine .
I looked and said you should lap that ; and your key isn't seated .
Do you have any laping compound ? Answer yes . Then .
Im going to tap the key in .
Ok` good luck . More advice unheeded .
 
Dawg Im trainable !
Cleaned another putty knife , exact same operation . No damage .
Go for the the 6" putty knife . in hand ready to go : stop an put your gloves on Dummy .
Wahla no damage !
 
Last edited:
Did you guys have good weather the whole weekend? I don't remember a 4th weekend without rain somewhere until the past one.
 
Mother nature won this weekend, 2 nights rained out Lucas Oil race 12 grand Fri, 20 grand Saturday race.
And yes the best of the best were there, yes Larson was there lol
 
You must log in or register to reply here.
Back
Top