So I'm using a PZ22 carb, got the jet needle clip in the middle groove, float height at .860". Nothing crazy or experimental going on here, but for some reason my kart won't idle properly until the mixture screw is 1 3/4 turns out, and I get the highest RPM at 2 1/4 turns out. And not only is that way far off from where most other drivers are, but my engine also seems to hesitate really bad every time I start it up. Cold or warm, it'll idle really low (1100 to 1300) for up to 15 seconds before the RPMs go to their intended range (1800-2000).
Really not sure where the issue lies, the weather isn't crazy (usually 85F - 90F, humidity 50% - 60%), and my setup isn't exactly experimental. I was wondering if it was an issue that my fuel pump vent was covered by some synthetic gel (suggested by a friend), but I was promptly told it was a non-issue.
Any advice? I'm so lost lol
Really not sure where the issue lies, the weather isn't crazy (usually 85F - 90F, humidity 50% - 60%), and my setup isn't exactly experimental. I was wondering if it was an issue that my fuel pump vent was covered by some synthetic gel (suggested by a friend), but I was promptly told it was a non-issue.
Any advice? I'm so lost lol