DepDaddy
Member
I consider myself fairly intelligent, but I am having the worst time trying to remove a clutch from a KT100 I acquired. It is a wet clutch, brand unknown, supported by a 3rd bearing. The starter goes inside the allen head to start it...does this "unscrew" the other way to remove the bearing support? once that is off do I use a clutch puller from there? This is the most logical way I can think of.
If I am correct above, do I need to use a piston stop to get it? I tried and the darn this is pretty tight...I don't want to do it too hard because I feel like I could break or bend something.
Help!!
Thanks.
David
If I am correct above, do I need to use a piston stop to get it? I tried and the darn this is pretty tight...I don't want to do it too hard because I feel like I could break or bend something.
Help!!
Thanks.
David