sneaks12303
Member
Lets finish this project. Get some aluminum L-bar and make yourself a brace/splash guard where the "low oil sensor" was . This will help keep the oil where you want it during cornering
Gotta do more honing. Its a tight .0025" . Since I'm using alky , I can stay a lttle tight..I'm hoping for cooler running temps.Looking good Sneaks!!!
You bring up a great point. We all deal with the sidecover bolts in different ways but no one has figured out why this happens..
goes right there
I've got a motor at this very point....I might give this a try also....can't hurt, but....i'll use 'blue' loctite'.With the Arc 6271 I'm about .003" in the hole
Added studs and short block is done. Time for a head. How about a 27mm Hemi head ? or maybe a 29mm intake 14cc . Not sure yet...
hey sneaks...i'm critic'g, not knit-pick'n, but....I think you want ur 'baffle' parallal to the bottom of the case if ur intent is too keep the oil from sloshing side to side. As it shows...by the time you mount 'that' motor on a 10-15* mount, ur baffle will only 'see' abt 1/2 of the baffle....(as I see it) jst say'nGoing with an older NR280-0611 cam and new GX160 lifters. The short ones...
Sure , like the Raceseng windage tray...hey sneaks...i'm critic'g, not knit-pick'n, but....I think you want ur 'baffle' parallal to the bottom of the case if ur intent is too keep the oil from sloshing side to side. As it shows...by the time you mount 'that' motor on a 10-15* mount, ur baffle will only 'see' abt 1/2 of the baffle....(as I see it) jst say'n
Is it me or the way that deck looks ? looks like a cover over the block deck
http://karting.4cycle.com/attachment.php?attachmentid=183&d=1386942307
http://karting.4cycle.com/attachment.php?attachmentid=211&d=1387631474
Just an illusion
About .500" in the picture, lol. But at TDC its somewhere near .003"-.005"How far in the hole is that piston in the last picture Sneaks?